How much to tighten O-ring fittings

Information on some common auto air conditioning topics.
Archived Forum

Moderators: bohica2xo, Tim, JohnHere

Post Reply
Osiris610
Posts: 3
Read the full article
Joined: Mon Apr 09, 2018 12:57 pm

How much to tighten O-ring fittings

Post by Osiris610 »

How tight should I make automobile O-ring A/C fittings? Is finger-tight enough?

Thanks, Mike Whalen
User avatar
Cusser
Preferred Member
Posts: 846
Joined: Sun Apr 24, 2016 6:29 am

Re: How much to tighten O-ring fittings

Post by Cusser »

I do tighter than finger tight, but not gorilla; so that's not much help.

With an O-ring, the compression forces the O-ring to expand and seal. So I'm saying firm, and when you pull a vacuum or check with bubble solution after refrigerant fill, you should know if you need to tighten a tad more.

Use new refrigeration O-rings only, and oil them with a small amount of refrigeration oil before installing.
Osiris610
Posts: 3
Joined: Mon Apr 09, 2018 12:57 pm

Re: How much to tighten O-ring fittings

Post by Osiris610 »

Just what I needed to know. Thanks!
pete_89t2
Posts: 32
Joined: Thu May 04, 2017 9:38 am

Re: How much to tighten O-ring fittings

Post by pete_89t2 »

One other point you need to know about installing O-rings is to never install them dry. Always lube them with whatever compressor oil your AC system uses prior to installation.
Post Reply