Search found 8 matches

by dorkshoei
Tue May 31, 2022 3:18 pm
Forum: Automotive Air Conditioning Procedures, Tips and FAQ.
Topic: Procedure for Nissan Leaf
Replies: 16
Views: 19157

Re: Procedure for Nissan Leaf

JohnHere wrote: Tue May 31, 2022 2:50 pm For reference, what was the actual ambient temperature? If it was 70F or below
70. I'll reconnect gauges when it's 80+ air temp and report back.

Thanks again!
by dorkshoei
Tue May 31, 2022 2:31 pm
Forum: Automotive Air Conditioning Procedures, Tips and FAQ.
Topic: Procedure for Nissan Leaf
Replies: 16
Views: 19157

Re: Procedure for Nissan Leaf

I have no idea if it's correct at this point. I got the full 12oz of the first can in and 3oz of the second can. Compressor was running most of the time. I don't recall what the gauges were reading. Should I hook them up again? What should I expect to see? A/C seems to be working fine, at least bas...
by dorkshoei
Tue May 31, 2022 1:54 pm
Forum: Automotive Air Conditioning Procedures, Tips and FAQ.
Topic: Procedure for Nissan Leaf
Replies: 16
Views: 19157

Re: Procedure for Nissan Leaf

I doubt it was the valve. The compressor shutting off could have been due to the thermistor on the evaporator sensing that the evap was approaching freezing. Also, once the system pressure reaches about 70 PSI with the compressor off, the refrigerant will stop flowing out of the can because the can...
by dorkshoei
Tue May 31, 2022 12:40 pm
Forum: Automotive Air Conditioning Procedures, Tips and FAQ.
Topic: Procedure for Nissan Leaf
Replies: 16
Views: 19157

Re: Procedure for Nissan Leaf

They do almost always ship the compressor filled with the required oil amount for the full system. But 1st startup in the assembly plant is usually very special, takes place with the ECM being controlled at end of line tester, and they start the compressor with a sequence that gently, slowly pumps ...
by dorkshoei
Sun May 29, 2022 11:46 am
Forum: Automotive Air Conditioning Procedures, Tips and FAQ.
Topic: Procedure for Nissan Leaf
Replies: 16
Views: 19157

Re: Procedure for Nissan Leaf

Right...presuming you now have the full 5 ounces of oil installed, assemble the system, pour in the dye in the proper amount and in a convenient place (like into a hose end, then reconnect same), evacuate the system well, verify that it holds vacuum, then charge it to specs, check pressures and cen...
by dorkshoei
Sat May 28, 2022 9:57 am
Forum: Automotive Air Conditioning Procedures, Tips and FAQ.
Topic: Procedure for Nissan Leaf
Replies: 16
Views: 19157

Re: Procedure for Nissan Leaf

If it's an all-in-one unit, the electric motor that drives the compressor is housed within the same case, which means that you won't find an external shaft or flange to rotate as you would on a clutch-type compressor. The former is what I thought it might be. No worries. I appreciate the suggestion...
by dorkshoei
Fri May 27, 2022 11:17 am
Forum: Automotive Air Conditioning Procedures, Tips and FAQ.
Topic: Procedure for Nissan Leaf
Replies: 16
Views: 19157

Re: Procedure for Nissan Leaf

Thanks for the help. Yes I was concerned about the ability to add all the oil in via the yellow charge hose. It seemed impractical/messy etc. When I had the compressor removed I don't recall seeing any way to turn the compressor by hand but I will recheck. To remove it the right front wheel has to c...
by dorkshoei
Fri May 27, 2022 12:21 am
Forum: Automotive Air Conditioning Procedures, Tips and FAQ.
Topic: Procedure for Nissan Leaf
Replies: 16
Views: 19157

Procedure for Nissan Leaf

I've read the Evacuate and Charging procedure here. I have a Nissan Leaf S electic vehicle (no heat pump). All the R134a has escaped. I'm replacing the condenser (it has built in dryer) which had supposedly developed a crack but I have my doubts (but the system has been open to atmosphere for long e...