For peace of mind, I think buying a new line will be money well spent.

My first inclination is to recover/evacuate/recharge to get the correct amount of refrigerant into the system, and then see if the compressor runs normally. Even though the compressor engages when you jump it and the system blows cold, it could still be low on charge. The specifications that I have ...

Before we discuss further, let me ask these questions: After you installed the new Delphi compressor, did you attain a full system charge of 32 ounces, or only a partial charge? The reason I ask is that according to the Field Service Manual, your car has a variable-displacement compressor with a mec...

The cleaned-up end looks pretty good. But from what I can tell, it still shows some pitting and an indentation where the o-ring goes. I would replace the line if you can locate one. Nothing worse than having to repeat the job due to a questionable component that fails right after completion.

90efAACIF wrote: ↑Wed Apr 24, 2024 10:43 am makes me wonder if there are scenarios where the refrigerant might start to condense in the suction line as it makes its way to the compressor suction port such as at an abrupt reduction in line diameter at fittings.

I doubt it.

The system might be low on refrigerant, not unusual for a vehicle of that age. When you say the pressures are good, have you actually connected a Manifold Gauge Set to check them? Is the system all original, and has it ever been serviced?

I had the handwheel closed to hi side during charging, only was open for vacuum and leak tests. I would like to know more about liquid charging to the hi side. I have heard this can be a bad thing? Great that you had the high-side handwheel closed during charging. As for leak testing, one point tha...

A few things come to mind. That high side handwheel on the Manifold Gauge Set (MGS) should be closed at ALL times (this is an important safety issue) except when evacuating a system or charging liquid into the high side with the engine off. You will still get a gauge reading on the high side with th...

Sure...Is the fan working? Good airflow through the condenser? Fan shroud in place? Air going around the condenser instead of through it? Anything externally blocking the condenser, like leaves or a plastic bag? Is the condenser internally blocked due to a faulty compressor shedding debris? Is the c...

Found this tid bit of info on the can of Canadian Tires canister of 12a refridgerant. Word for word it says...not for use or sale in the USA but in next sentence says get this .....Made in USA.Consumer Commodity. Then I look at more of the cans fine print with magnifing glass and says.louisville TN...