Search found 5 matches
- Sat Nov 09, 2019 12:12 am
- Forum: Automotive Air Conditioning Forum
- Topic: Evaporator temperature sensor placement
- Replies: 21
- Views: 31036
Re: Evaporator temperature sensor placement
a 30 minute vacuum after a system opening is not long enough to pull out moisture and leftover flushing vapors esp in temps below 85 degrees and often times the vac pumps used are too weak to pull deep enough giving higher pressures and weaker performance plus contaminates the oil and desiccant resu...
- Sun Jun 30, 2019 7:37 pm
- Forum: Automotive Air Conditioning Forum
- Topic: New Motorcraft compressor, clutch wouldn't turn by hand, squealed after installation
- Replies: 17
- Views: 18565
Re: New Motorcraft compressor, clutch wouldn't turn by hand, squealed after installation
sounds like a air flow problem across the condenser or the condenser itself/expansion valve or even some form of contamination in the system, you should be getting your pressure readings in the open sun and at 60 degree ambient temps your pressures are too high and even set on high max output the co...
- Sat Dec 30, 2017 12:01 am
- Forum: Automotive Air Conditioning Forum
- Topic: What would cause this new compressor failure
- Replies: 4
- Views: 7921
Re: What would cause this new compressor failure
honda has known problems with relays causing clutch failures
- Fri Dec 29, 2017 11:56 pm
- Forum: Automotive Air Conditioning Forum
- Topic: 1986 El Camino (G Body) a/c has no volume.....
- Replies: 1
- Views: 6793
Re: 1986 El Camino (G Body) a/c has no volume.....
is the fan wiring backwards?
is where the fan pulls air from blocked?
pull the fan motor and check for running speed?
does fan motor get proper voltage to operate properly?
is where the fan pulls air from blocked?
pull the fan motor and check for running speed?
does fan motor get proper voltage to operate properly?
- Fri Dec 29, 2017 11:47 pm
- Forum: Automotive Air Conditioning Forum
- Topic: Building a air condition system
- Replies: 3
- Views: 8826
Re: Building a air condition system
i would look over the other machine's parts for numbers use the discontinued part numbers to look for used parts or old stock on the internet, as a last resort start measuring the parts to match them up as close as possible to whats available being sold or have it made for you. you will need the ori...